User guide

To add support for services on a target device:
1. In a Units View window containing target devices (see Accessing Units View windows on
page 118), click on a target device name.
2. In the side navigation bar, click Services. The Unit Services window will open, listing the
services that are supported.
3. Click Add. The Add Service Wizard will appear.
4. If the target device does not have an address in the DSView 3 software database, you will
be prompted to enter it. After you enter the name, click Next.
5. The Select the Procedure window will open. You may add support for the service either by
discovery of services running on the target device or by selecting from all available
services. Enable the radio button for adding with discovery or without discovery, then
click Next.
If you chose to add a service by discovery, a Request in Progress display will appear
before the next window opens.
6. The Select Service window will open. Select the services from the Available Services (or
Services Found) list, then click Add. The selected services will be moved to the Services to
Assign list.
To remove services from the Services to Assign list, select the services, then click
Remove. The selected services will be moved to the Available Services (or Services
Found) list.
Click Next.
7. The Completed Successful window will open. Click Close.
To change service options:
1. In a Units View window containing target devices (see Accessing Units View windows on
page 118), click on a target device name.
2. In the side navigation bar, click Properties, then click Services. The Unit Services window
will open.
3. Click on a service name.
4. Enable the radio buttons to enable options, then click Save.
To remove support for a service on a target device:
1. In a Units View window containing target devices (see Accessing Units View windows on
page 118), click on a target device name.
Chapter 10: Managing Units 171