User guide

.....51
Migration CLI
The Migration CLI is a tool that allows you to configure an ACS 6000 console server that is running
scripts based in the ACS advanced console server. For full configuration and management
commands, it is recommended you use the ACS 6000 console server’s CLI.
NOTE: References to an ACS advanced console server in this section refer to any advanced console server
other than the ACS 6000 console server.
In the ACS 6000 console server, the login profile for the user “root” goes directly to the shell
prompt. This will allow the root user to run Migration CLI commands out of the ACS 6000 console
server. A new group, “login-profile-shell,” is created with only root as a member. To run commands
based from an ACS advanced console server, a root user should type CLI before the command.
Access rights
The access rights on the ACS 6000 console server are based on authorization groups. The
administrator configures the serial ports the group can access. To allow you to configure access
rights, the following table displays authorization groups that will be created on the ACS 6000
console server when using the Migration CLI.
Group Members Permissions
cli_mus_
ttySxx
Users who can open a second session to a
serial port.
Access to a serial port in a muli-session (read/write
or read only)
cli_power_
ttySxx
Users who have power control in a serial
port.
Power control (on/off/cycle) of outlets merged to a
serial port.
cli_access_
ttySxx
Users who can access a serial port in a
single session.
Access to a serial port in a single read/write
session.
cli_pmd_
<username>
<username> Power control of the outlet.
Access Rights Groups
Exceptions
This section will list all ACS advanced console server CLI commands not available in the Migration
CLI for the ACS 6000 console server. For a list of available commands, see the Avocent ACS
Installation/Administration/User Guide.
The following commands or values are not supported by the Migration CLI:
Command Value or Descriptions
administration
backupconfig
loadfrom sd
N/A
Commands Not Supported by the Migration CLI