User guide

Port Access and Configuration Examples.....25
--:- access cli->ls
ACS6016-0011223344/
21-67-72-p-1/
21-67-72-p-2/
21-67-72-p-4/
myPDU/
Type show to see the content of the page
--:- access cli->
Connect to a Device Console Connected to a Serial Port
The following procedure is an example of how an administrator or an authorized user can connect
to a device console when the device is connected to a port that is enabled and configured with the
CAS Profile.
To connect to a device console connected to a serial port:
NOTE: The serial port must already be configured and enabled prior to this procedure. See Port
Configuration Examples on page 27.
1. Log into the CLI and enter cd access to navigate to the Access level.
--:- / cli-> cd access
--:- access cli->
2. Enter connect <serial_port_name>. If authentication is configured for the port, the Password
prompt appears when single sign-on is disabled.
--:- access cli-> connect 77-77-70-p-2
password:
NOTE: The connect command above shows a connection to a port that has an alias of 77-77-70-p-2.
3. If prompted, enter the password for the port. The following prompt appears.
Type the hot key to suspend the connection: <CTRL>z
4. Press Enter to continue. You are connected to the device that is connected to the port. The
window shows the initial display for the device (usually a console banner and login prompt). An
example is shown below.
Ubuntu 6.06.1 LTS fremont-techpubs ttyS2