User guide

18.....Avocent® ACS6000 Advanced Console Server
NOTE: Use this command to restart the sequence number.
Syntax:
--:- / cli-> opiepasswd -f -c <username>
Example:
opiepasswd -f -c teste
Adding teste:
Only use this method from the console; NEVER from remote. If you are using telnet, xterm, or a
dial-in, type ^C now or exit with no password.
Then run opiepasswd without the -c parameter.
Using MD5 to compute responses.
Enter new secret pass phrase:
Again new secret pass phrase:
ID teste OTP key is 499 AC0241
FOOD HUGH SKI ALMA LURK BRAD
wiz
Configures the IP parameters for the Eth0 interface. Shows the current configuration and asks for
new values for the following parameters:
• Status of the interface (enabled or disabled)
• IPv4 method (dhcp or static)
• IPv6 method (dhcp or static)
• IP address, mask and gateway (if static is chosen for either of the previous parameters)
• DNS Primary Server, Secondary Server, Domain Name and Hostname
• Enable or disable IPv6 support
After setting all parameters, confirm that all parameters are correct to save them.
Special Multi-session Commands
The following commands require navigation to an enabled and configured port to which one or
more users are simultaneously connected. To get to the port, enter the following command.
--:- / cli-> cd access/<serial_port_ID>