User guide

CLI Command Set.....17
--:- / cli-> cd access/<PDU_ID>
2. Launch the power command with a specific outlet (number or name), range of outlets (use a
hyphen to specify the range) or list of outlets (number or name separated by a comma).
--:- <PDU_ID> cli-> [cycle|on|off][<outlet name>|<outlet number>]
-or-
--:- <PDU_ID> cli-> [cycle|on|off]<outlet number>-<outlet number]
-or-
--:- <PDU_ID> cli-> [cycle|on|off]<outlet number>,<outlet number>
To power control (on, off, cycle, lock, unlock) outlets of one specific PDU under the
power management level:
1. Go to the outlet level for the specific PDU.
--:- / cli-> cd power_management/pdus/<PDU_ID>/outlets
2. Launch the power command with a specific outlet number, range of outlets (use a hyphen to
specify the range) or list of outlets (number or name separated by a comma).
--:- outlets cli-> [cycle|on|off] [<outlet number>]
-or-
--:- outlets cli-> [cycle|on|off] <outlet number>-<outlet number]
-or-
--:- outlets cli-> [cycle|on|off] <outlet number>,<outlet number>
passwd
Configure the password for the current user. The terminal does not echo the password.
Syntax:
--:- / cli-> passwd
opiepasswd
Configure a one time password (OTP) for the local user. After you type the command, you will be
asked for the pass phrase to use for the OTP.