User guide

64 Cyclades® CS Console Server Installation, Administration and User Guide
b. To select multiple ports in a range, click the first port in the list and then hold down the
Shift key while selecting the last port or ports in the range.
c. To select multiple ports that are not in a range, click the first desired port in the list and
then hold down the
Ctrl key while selecting another port or ports.
3. Go to the desired procedure from the following list.
To enable or disable serial ports:
1. Go to Ports - Physical Ports and select a port or ports to modify.
2. To enable selected ports, click the Enable Selected Ports button.
3. To disable selected ports, click the Disable Selected Ports button.
NOTE: By default, all Serial Ports are disabled from the factory. The Administrator can activate and assign
specific users to individual physical ports.
4. Click apply changes.
General form
Under Ports - Physical Ports, if you select one or more ports from the ports list and click the
Modify button, the General form appears as shown in the following form.
Table 8.1: List of Procedures for Serial Port Configuration
To enable or disable serial ports: on page 64
To configure a serial port connection protocol for a console connection: on page 67
To configure user access to serial ports: on page 70
To configure data buffering for serial ports: on page 72
To configure multiple sessions and port sniffing for one or more serial ports: on page 74
To configure TCP port number, STTY options, break interval and the login banner for a serial port connected to
a console: on page 75