User guide

63
CHAPTER
8
Ports Menu and Forms
Physical Ports
When Physical Ports is selected under Ports - Physical Ports in Expert mode, the following
form appears.
Figure 8.1: Ports - Physical Ports
Using this form, you can enable or disable ports and configure parameters for individual or a group
of serial ports.
You can select contiguous serial ports on the form by using the
Shift key or non-contiguous ports
by using the
Ctrl key on your keyboard. You can select Enable Selected Ports or Disable Selected
Ports by pressing the corresponding button.
You can select the Modify All Ports button to specify the same parameters for all the serial ports or
you can select the Modify Selected Ports button and set values for an individual or a group of ports.
To select one or more serial ports:
1. Go to Ports - Physical Ports in Expert mode The Physical Ports form appears.
2. To select a port or ports, perform one of the following steps.
a. To select a single port, click the port.