User guide
18 Cyclades® CS Console Server Installation, Administration and User Guide
If the DHCP is enabled, the following form appears.
Figure 4.2: Wizard - Step 1: Network Settings - DHCP Enabled
To configure the network settings:
1. Select Step 1: Network Settings. The DHCP form is displayed. By default, DHCP is active.
NOTE: If DHCP is enabled, a local DHCP server assigns the console server a dynamic IP address that can
change. The administrator chooses whether or not to use DHCP during initial setup.
2. If you are using DHCP, proceed to Step 2: Port Profile, if not, click on the checkbox to deselect
DHCP and enter your network settings manually.
3. Enter the required network information.
4. Select apply changes to save configuration to Flash.
5. Select the Next button or proceed to Step 2: Port Profile.