User guide

Parameter Description
Power Cycle Interval
The interval in seconds between Off and On actions for the power cycle
command. Default: 15.
Syslog
When enabled, the PDU will send syslog messages to the appliance.
Default: Enabled.
Buzzer Enables or disables the PDU’s buzzer. Default: Enabled.
SW Overcurrent Pro-
tection
When enabled, the software’s overcurrent protection is on. Default: Dis-
abled.
To copy/clone the configuration of one port to other ports:
1. Select Ports - Serial Ports.
2. Click the checkbox for the serial port you want to clone.
3. Click the Clone button.
4. Enter the serial port(s) to be configured in the Copy Configuration To field and click Save.
NOTE: If the selected port is configured as a CAS Profile, the following parameters will not be copied: Port Name,
TCP Port Alias, IPv4 Port Alias, IPv6 Port Alias and Power (merged outlets).
To reset one or more serial ports to their factory configuration:
1. Select Ports - Serial Ports.
2. Click the checkbox for one or more serial ports you want to reset to their factory
configuration, then click the Reset To Factory button.
NOTE: Serial ports are set to the CAS Profile and disabled in the factory configuration.
Auxiliary ports
On the Auxiliary Ports screen, you can enable the auxiliary port and configure it based on the
type of connected device.
To configure an appliance with an internal modem:
1. Select Ports - Auxiliary Ports.
2. Use the drop-down menus to configure the Dial-in settings.
3. Configure the PPP parameters (address, authentication, and so on) and click Save.
To configure or edit auxiliary port with connected PDU:
1. Select Ports - Auxiliary Ports.
44 Cyclades™ ACS 6000 Advanced Console Server Installation/Administration/User Guide