User guide

d. For Avocent/Cyclades PDUs, enter the power cycle interval and then use the drop-
down menus to enable or disable Syslog, Buzzer and SW Overcurrent Protection.
5. Click Save.
Parameter Description
Physical
Enable Cisco RJ-45
Pin-Out
Defines the serial port pinout. Default: Disabled.
Status
Defines the status of the serial port as either enabled or disabled.
Default: Disabled.
Speed
Defines the speed as 300, 1200, 2400, 4800, 9600, 19200, 38400,
57600 or 115200. Default: 9600.
Parity Defines the parity as either Even, Odd or None. Default: None.
Data Bits Defines the data bits as either 5, 6, 7 or 8. Default: 8.
Stop Bits Defines the stop bits as either 1 or 2. Default: 1.
Flow Control
Defines the flow control as none, hardware, software, RxON software
or TxON sofware. Default: None.
Power
PDU Type
Defines the type or vendor of the PDU connected to the serial port.
• Auto - the vendor will be detected.
• Avocent-Cyclades - Avocent-Cyclades PM PDU family.
• SPC - SPC power control device family.
• Server Tech - Server Tech family.
Default: Auto.
Enable Speed Auto
Detection
When enabled, detects the speed of the port. Default: Disabled.
Pooling Rate
The interval in seconds to update information from the PDU. Default:
20.
For Avo-
cent/Cyclades PDUs
Table 3.7: Power Parameters
Chapter 3: Accessing the Console Server via the Web Manager 43