Service manual

64 Cyclades ACS 5000 Advanced Console Server Command Reference Guide
# passwd <username>
2. Make sure the physical connection between the console server and the servers is correct.
3. Confirm the communication parameters (9600 bps, 8N1) are set on both the server and the
console server.
4. Make sure the server is configured to route console data to its serial console port
(Console Redirection).
5. Telnet to the server connected to Port 1.
6. From a server on the local network (not from the console), try to Telnet to the server connected
to the port 1 of the console server using the following command.
# telnet <ip address> <TCP port>
7. A Telnet session should open on the server connected to Port 1.
8. To activate and save the changes run the following commands.
# runconf
# saveconf
Terminal Server (TS) profile
The console server provides features for out-of-band management through the configuration of
terminal ports. A TS profile allows a terminal user to access a server on the network. The terminal
may be either a dumb terminal or a terminal emulation program running on a workstation. Figure
4.3 displays an example of a TS profile. Descriptions follow in Table 4.11.