Service manual

56 Cyclades ACS 5000 Advanced Console Server Command Reference Guide
Serial ports general parameters
To configure general parameters:
1. Execute the following command for one or multiple serial ports. Refer to Table 4.2 for port
configuration parameters.
cli> config physicalports <'all' or range/list[1-4] general
[parameter] <value>
2. Activate and save your configuration.
Table 4.2: Serial Port General Configuration Parameters
Parameter Value Description
alias <server alias> To name a server connected to the serial port.
datasize <number[5-8]> To configure number of bits per character.
dcdstate disregard|regard To enable or disable Data Carrier Detect (DCD).
flow hard|none|soft To set the flow control.
parity even|none|odd To configure parity.
pmsessions none
ssh
ssh_telent
telnet
To select a connection method to PM IPDU through the serial
port, in order to execute PM commands.
protocol bidirectionaltelnet
consoleraw
consolessh
consoletelnet
consoletelnetssh
cslip
local
pm
ppp
pppnoauth
rawsocket
slip
sshv1
sshv2
telnet
To configure the serial ports connection protocol. See
Connection Profiles and Protocols on page 55 for a
description of each connection profile.
speed <baud rate> To configure the serial port speed.
stopbits <number[1-2]> To configure the number of stop bits.