Service manual

14 Cyclades ACS 5000 Advanced Console Server Command Reference Guide
NOTE: If the gateway address is IPV6 link_local (range identified by the first 10 bits equal to 1111111010), then
the interface id is required: config network stroutes add default gateway <gateway_IP_address> interface
<interface_ID>
Activate and save your configuration.
cli> config runconfig
cli> config savetoflash
Host settings
To configure host settings:
1. Enter the following string at the CLI prompt. Refer to Table 2.3 for host settings parameters
and values.
cli> config network hostsettings <parameter> <value>
2. Activate and save your configuration.
.
Table 2.3: Host Settings Parameters and Values
Parameter Level1 Parameter Level2 Value Description
banner <console banner> Banner for the user shell
bonding
miimon
updelay
<number>
<number>
Redundancy for the ethernet
interface
The interval in which the active
interface is checked to see if it is
still communicating (in
milliseconds)
The time the system waits to
make the primary interface active
after it has been detected as up
(in milliseconds)
dhcp yes|no Enable or disable DHCP
domain <domain name> Domain name
hostname <string> Console Server name
mtu <number[200-1500]> Maximum Transmission Unit used
by the TCP protocol
primdnsserver <IPv6_address>/<prefix_length> Primary DNS Server (IPv4 or
IPv6)