Service manual

Chapter 1: Using the Command Line Interface 7
CLI command arguments
Command arguments are used when CLI is invoked in the command line mode in the Linux shell
or in a batch mode
show Displays the configuration parameter(s). When combined with a command name
supported at the current level, the applicable information or parameter
is displayed.
Table 1.7: CLI Command Arguments
Argument Description
-q Suppress the output of error messages from CLI.
-t <time> Timeout in minutes, default is 10 minutes.
-T Disable the idle time-out. Same as -t 0.
-s
batch mode only
Save changes to flash. This is the same as savetoflash command.
-r
batch mode only
Activate changes. This is the same as runconfig command.
-f <filename> Executes the commands in the file <filename>.
Table 1.6: CLI Global Commands (Continued)