Service manual

Chapter 6: Power Management 107
It was impossible to start a Power Management Session
You can't access any Power Management functionality.
Please contact your Console Server Administrator.
c. If you can access outlet(s) but have no access to outlet(s) of a specific server, the
following message appears.
You cannot manage the outlet(s) of this server.
Please enter the outlet(s) (or '?' for help):
3. Enter the outlet(s) you want to manage. The main menu appears only if you have permission
for those outlet(s). Type
h to display the help information.
4. Check the status of the server's outlet(s) by typing
8 to select Status.
5. If the outlet(s) are locked you must unlock them first. Type 7 to select Unlock.
6. The Cycle command turns off the outlet for a few seconds and turns it back on.
Type
5 to select Cycle.
To manage other outlets:
Perform the following procedures if you need to access other outlets.
1. Type
8 to select Status to view the outlets you are authorized to manage.
2. Type
10 to select Other, and select the outlet you want to manage. You should have
authorization to the manage the outlets entered.
Table 6.2: IPDU Appliance Command Menu
Command Description
Exit Exits the power management session.
Help Display a list of available commands with a description.
On Turn outlet(s) On.
Off Turn outlet(s) Off.
Cycle Turn an outlet Off and On again (recycle power).
Lock Locks a set of outlets in On or Off state to avoid accidental changes.
Unlock Unlocks the selected outlets.
Status Displays the status of the selected outlets.
Interval Configures the post turn on delay.
Other Allows you to manage other outlets.