User guide

40 AutoView Installer/User Guide
Figure B.3: Administrator Functions Menu
12. Press the Escape key repeatedly to exit from the OSD menu.
13. Power down the secondary unit and disconnect the keyboard and monitor.
To confi gure your primary unit:
1. Select cables with appropriate connectors and length.
2. Connect your VGA monitor cable and keyboard to the appropriate ports
on the rear of the primary switch.
3. Locate the power cord that came with your primary AutoView unit. Plug
it into the IEC power connector on the rear of the unit. Make sure that
the power switch is off, then connect the other end of the power cord into
an appropriate AC wall outlet. This outlet must be near the equipment
and easily accessible to allow for unplugging prior to any servicing of
the unit.
4. Power up the primary unit and press the Control key twice to activate the
Administrator Channel list.
5. Press the Control key twice more to activate the Administrator
Command Menu.
6. Using the Arrow keys, highlight and select Administrator Functions to
display the Administrator Menu.
7. Highlight Unit Confi guration and press Enter.
8. Highlight option 2, Paired (Master) and press Enter.
9. Press Escape repeatedly to exit the OSD menu.
10. Power down the primary unit and disconnect the monitor.
Administrator Menu
Avocent Control Panel
ESC-previous
Select Unit Configuration
1: Tiered (Default)
2: Paired (Master)
3: Paired (Slave)
ENTER-accept