User guide

Chapter 3: Operations 33

Additional Command Mode hotkey sequences

In addition to switching channels, you can also use the Command Mode to

control a variety of other features on your AutoView system. The following

table describes these hotkey sequences.

Keyboard Hotkey Sequences

This Key Sequence Does This

<CM>Kn<Enter> Sets the keyboard scan set where n is a scan set number 1-3.

<CM>MR<Enter> If you hot-plug your mouse cable, you may experience a loss

of mouse signal. Use this command to restore the signal if

you are using a PC with a standard PS/2 mouse driver.

<CM>MW<Enter> If you hot-plug your mouse cable, you may experience a

loss of mouse signal. Use this command to restore the

signal if you are using a PC with a Microsoft IntelliMouse or

other wheel mouse driver.

<CM>AV<Enter> Displays the current ﬁ rmware version of your AutoView.

<CM>H1<Enter> Changes the hotkey sequence to the default: (NumLock, -).

<CM>H2<Enter> Changes the hotkey sequence to the 1st alternate:

(NumLock, *).

Changes the hotkey sequence to the 2nd alternate: (Ctrl, ~).

<CM>ZM<Enter> Use this command to resynchronize the mouse after a

device or computer hot-plug. Repeat, if necessary, until

synchronization is re-established.

NOTE: Using this command while the mouse is operating

correctly will cause the mouse to lose sync.