User guide

Chapter 3: Operations 21
4. Press the Up or Down Arrow key to select a specific menu or command.
5. Press Enter to access a menu or activate a command.
-or-
Press Escape to exit the window without saving changes.
Adding and Maintaining Channels
You may add, delete or edit a channel whenever you want to change your
AutoView system. You will have the ability to name the channel, set the port
address, set the time that the channel ID will flash on the screen and establish
the scan dwell time, if appropriate.
To add a new channel to the base unit:
1. Press the keyboard Control key twice within one second. The Administrator
Channel List appears.
2. Press the keyboard Control key twice within one second again. The
Administrator Commands Menu appears.
3. Highlight Channel Maintenance and press Enter.
4. Highlight Add Channel and press Enter.
Figure 3.4: Add Channel Menu
5. Type in a new channel name, up to 14 characters long, and press Enter.
6. Type a letter in the channel address for the PC you are naming and
press Enter.
Configure Channel
Avocent Control Panel
ESC-previous
Enter Channel Name
ENTER-accept