User guide

72 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide

Set telephone extension option

This command enables/disables “line-in-use” and “extension pickup” options.

If the line is in use and the modem receives an ATDT command to dial out, the modem will not go

off hook and will display the “LINE-IN-USE” result code. If the modem is off hook and the

extension is picked up, the modem will drop the connection and display the “OFF-HOOK

INTRUSION” result code.

AT S registers

The S registers use the following format: ATSr=n<CR> where the “r” is the S register number and

“n” is the parameter to set it to. To read the current contents of an S register, issue an

ATSr?<CR>

command where “r” is the register in question. The modem will then display the value of the S

V92

downstream

V92 56000, 54667, 53333, 52000, 50667, 49333, 48000, 46667,

45333, 42667, 41333,, 40000, 38667, 37333, 36000, 34667,

33333, 32000, 30667, 29333, 28000

V92

upstream

V92 48000, 46667, 45333, 42667, 41333,, 40000, 38667, 37333,

36000, 34667, 33333, 32000, 30667, 29333, 28000, 26667,

25333, 24000

Table D.3: +MS Command Supported Rates (Continued)

Modulation Carrier Possible Minimum, Maximum, Receive and Transmit Rates

Table D.4: Set Telephone Extension Options

-STE=n Value Extension Pickup Line-In-Use

0 (default) Disabled Disabled

1 Disabled Enabled

2 Enabled Disabled

3 Enabled Enabled

Table D.5: AT S Registers

S0 0-255 Rings 0 Ring to answer on. ATS0=1<CR> means

answer call on first ring detected.

S1 0-255 Rings 0 Number of rings counted.

S2 0-127 ASCII 43 Escape code character.