User guide

38 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
To copy/clone the configuration of one port to other ports:
1. Select Ports - Serial Ports.
2. Click the checkbox for the serial port you want to clone.
3. Click the Clone button.
4. Enter the serial port(s) to be configured in the Copy Configuration To field and click Save.
NOTE: If the selected port is configured as a CAS Profile, the following parameters will not be copied: Port
Name, TCP Port Alias, IPv4 Port Alias, IPv6 Port Alias and Power (merged outlets).
To reset one or more serial ports to their factory configuration:
1. Select Ports - Serial Ports.
2. Click the checkbox for one or more serial ports you want to reset to their factory configuration,
then click the Reset To Factory button.
NOTE: Serial ports are set to the CAS Profile and disabled in the factory configuration.
Auxiliary ports
On the Auxiliary Ports screen, you can enable the auxiliary port and configure it based on the type
of connected device.
To configure an appliance with an internal modem:
1. Select Ports - Auxiliary Ports.
2. Use the drop-down menus to configure the Dial-in settings.
3. Configure the PPP parameters (address, authentication, and so on) and click Save.
To configure or edit auxiliary port with connected PDU:
1. Select Ports - Auxiliary Ports.
2. Click the Set Power button and use the drop-down menus to configure the physical settings.
3. Click Next or click the Power link.
a. Use the drop-down menu to select the PDU type.
b. Check the box to enable speed auto detection.
c. Configure the polling rate.
d. For Avocent/Cyclades PDUs, enter the power cycle interval and then use the drop-down
menus to enable or disable Syslog, Buzzer and SW Overcurrent Protection.
4. Click Save.
To configure or edit auxiliary port with a connected modem:
1. Select Ports - Auxiliary Ports.
2. Click the Set Dial-In button and use the drop-down menus to configure the Dial-in settings.