User guide
34 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
TCP Port Alias For a Telnet session: TCP port to connect directly to a serial port.
For SSH session: Alias of the port similar to ttySxx. Default: 70XX,
where XX is the serial port number.
Port IPv4/IPv6 Alias IPv4/IPv6 address used to connect directly to a serial port. Default:
not configured (empty).
Port IPv4/IPv6 Alias
Interface
Interface (ETH0/ETH1) associated with the IPv4/IPv6 alias. Default:
ETH0.
Allow Session Only if
DCD is On
When the DCD is OFF, the appliance will deny access for this serial
port. Default: Disabled (allow access if DCD is OFF).
Enable Auto Answer When the input data matches one input string configured in Auto
Answer, the output string will be transmitted to the serial port. Default:
Disabled.
DTR Mode DTR Mode can be set to the following:
• Always On.
• Normal - the DTR status will depend on the existence of a CAS
session.
• Off Interval - when the a CAS session is closed, the DTR will stay
down during this interval.
Default: Normal.
DTR Off Interval Interval in seconds used by DTR Mode Off Interval in milliseconds.
Default: 100.
Line Feed Suppression Enables the suppression of the LF character after the CR character.
Default: Disabled.
Null After CR
Suppression
Enables the suppression of the NULL character after the CR
character. Default: Disabled.
Transmission Interval The interval the port waits to send data to a remote client in
milliseconds. Default: 20.
Break Sequence Sequence used to send a break signal to the serial port. Default:
~break.
Break Interval Interval for the break signal in milliseconds. Default: 500.
Log In/Out Multi
Session Notification
Enables the notification to multi-session users when a new user logs
in or a user logs out. Default: Disabled.
Informational Message
Notification
Displays an information message when a target session is opened.
Default: enabled.
Data Buffering
Status Enables or disables data buffering. Default: Disabled.
Table 3.5: CAS Profile Parameters (Continued)
Parameter Description