User guide

Chapter 3: Accessing the ACS 6000 Console Server via the Web Manager 33
8. Click Save.
Table 3.5: CAS Profile Parameters
Parameter Description
Physical
Enable Cisco RJ-45
Pin-Out
Defines the serial port pinout. Default setting: Disabled.
Status Defines the status of the serial port as either enabled or disabled.
Default: Disabled.
Speed Defines the speed as 300, 1200, 2400, 4800, 9600, 19200, 38400,
57600 or 115200. Default: 9600.
Parity Defines the parity as either Even, Odd or None. Default: None.
Data Bits Defines the data bits as either 5, 6, 7 or 8. Default: 8.
Stop Bits Defines the stop bits as either 1 or 2. Default: 1.
Flow Control Defines the flow control as none, hardware, software, RxON software
or TxON software. Default: None.
CAS
Port Name Name associated with the serial port (as an alias). Default: <appliance
mac address>-p-<port number>.
Enable Auto Discovery The target name will be discovered and will be associated with this
serial port. If it fails, the Port Name will be used. Default: Disabled.
Enable Speed Auto
Detection
Tries to discover the speed of the serial port. This feature requires
additional configuration under the CAS Profile / Auto Discovery /
Settings page. Default: Disabled.
Protocol The protocol that will be used to access the serial port/target.
• SSH - SSH session.
• Telnet - Telnet session.
• SSH/Telnet - allow SSH session and/or Telnet session.
Default: SSH/Telnet.
Authentication Type Authentication type that will be used to authenticate the user during
target session. Default: Local.
Text Session Hot Key Hotkey to suspend the target session and go to the CLI prompt.
Default: ^Z (Ctrl-Z).
Power Session Hot Key Hotkey to suspend the target session and display Power Management
Menu to control the outlets merged to the target. Default: ^P (
Ctrl-P).