User guide

32 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
a. Enter the port name (when only one port was selected) or the port name prefix (when more
than one port were selected). The port name will be <port name prefix>-p-<port number>.
b. Check the box to enable auto discovery. In this case, the port name will be used when auto
discovery fails to discover the server name. Check the box to enable speed auto detection.
NOTE: Auto speed detection requires additional configuration in the CAS Profile-Auto Discovery Settings
screen.
c. Use the appropriate drop-down menus to set the protocol and authentication type.
d. Enter the text session hotkey and power session hotkey in the appropriate fields.
e. Enter the TCP port alias in the appropriate field.
f. Enter the IPv4 or IPv6 alias and its interface in the appropriate field.
g. To allow a session only if DCD is on and to enable auto answer, check the appropriate
boxes.
h. Use the drop-down menu to select the DTR mode and enter the DTR off interval.
i. Use the drop-down menus to enable or disable line feed suppression and NULL after CR
suppression.
j. Enter the transmission interval, break sequence and break interval in the appropriate
fields.
k. Use the drop-down menus to enable or disable log in/out multisession notification and
informational message notification.
5. Click Next or click the Data Buffering link and use the drop-down menus to enable and
configure data buffering.
6. Click Next or click the Alerts link.
a. Click Enable Alerts to enable detection of alerts.
b. Click Add to add an alert string. Enter the string in the Alerts String field and click Next to
return to the Alerts screen.
c. Check the box next to an existing alert and click Delete to delete the string.
d. Click Delete Any to delete all strings whether selected or not.
NOTE: Clicking Delete Any will delete all alert strings. Selecting all the alert strings and clicking Delete is not the
same functon as it will not delete alert strings not shown in the table.
7. Click Next or click the Power link.
a. Click Add to add a new outlet. Click Selected PDU and select a PDU from the list of
detected PDUs. Enter the outlet(s) in the Outlets field, and click Next.
b. Check the box next to an existing merged outlet and click Delete to delete it.
NOTE: Power is only available when a single serial port is selected.