User guide

20 Cyclades ACS 6000 Advanced Console Server Installation/Administration/User Guide
To configure Ports:
1. Select the Ports link in the content area.
2. Check the box(es) to enable all ports and/or to enable Cisco RJ45 Pin-Out to change the pin-
out when a Cisco cable is connected.
3. Use the appropriate drop-down menus to select the values for Speed, Parity, Data Bits, Stop
Bits, Flow Control, Protocol, Authentication Type and Data Buffering Status.
4. Select the Data Buffering Type. If using NFS, enter the NFS Server and NFS Path information
in the appropriate fields.
5. Click Next to configure users or click on the Network, Security or Users link to open the
appropriate screen.
To configure users and change the default user passwords:
WARNING: For security reasons, it is recommended you change the default password for both root and admin
users immediately.
1. Select the Users link in the content area.
2. Click a username (admin or root) and enter the new password in the Password and Confirm
Password fields.
-or-
Click Add to add a user. Enter the new username and password in the appropriate fields.
3. (Optional) To force the user to change the default password, select the User must change
password at next login checkbox.
4. Assign the user to one or more groups.
5. (Optional) Configure account expiration and password expiration.
6. Click Next.
7. Repeat steps 3-7 as needed to configure new user accounts and assign them to default groups.
NOTE: By default, all configured users can access all enabled ports. Additional configuration is needed if your
site security policy requires you to restrict user access to ports.
8. Click Save, then click Finish.
Expert Mode
The following tabs are available in the Side Navigation Bar of the Web Manager when an
administrator is in Expert mode.
Access
Click Access to view all the devices connected to the ACS 6000 console server.