Quick Start Guide

SmartEdge Industrial IoT Gateway
Quick Start Guide
POWER INPUT
An external power supply is required. Rating: 12VDC to 24VDC (+/- 10%), 18W minimum, 24W
recommended, LPS (Limited Power Source). Use 16-22AWG power supply wiring, stripped
back 4-5mm, twisted & optionally tinned. Find the black, 3 position terminal plug in the
included hardware kit. Insert the prepared wires into the terminal plug, observing proper
location. The wire polarities are indicated on the enclosure and shown below. An Earth GND
wire is recommended (not included).
Signal DC Input
Earth GND
- 0V (GND)
+ 12-24VDC
CAUTION: Verify terminal block wiring is correct, tight, and with no bare wiring exposed
INSTALLATION
Follow this installation process to connect your Avnet SmartEdge IIoT Gateway to the cloud.
1) Connect your SmartEdge Gateway to your Ethernet network, if available, by using one of
the two Ethernet Ports. If using wireless, this will be set up in a later step.
2) Plug in the correctly wired power supply plug to start the unit
3) Refer to the online datasheet (insert link to product web portal here) for detailed
information on the remaining hardware connections.
4) Download the mobile application to register your SmartEdge Gateway with the IoT
Connect cloud by scan the appropriate QR code below with your mobile device, or
search for <APP NAME> on the app store):
iOS Android
5) Signup: Launch the App and enter your
details to create a new account, or
Cancel to login to an existing account
6) Login: Enter your account email address
and password to login
7) Add Device, tap lower right, then tap
"Add Device" +
8) Connect to your device using your
mobile's WiFi settings
Apple iOS App
Store Link
QR Code
Android Play
Store Link
QR Code