User manual

II. Setting up the EKP-IV

There are lots of ways to customize the display on your EKP-IV. This section will review how to

configure the basic system settings as well as the settings on the Moving Map.

A. SYSTEM SETUP

The EKP-IV contains a highly detailed system of configurable options that allow the pilot to

customize the unit to his preference. The EKP-IV User Manual should be consulted for full Menu

setups and configurations, but a few of the important ones will be covered here below. All of the

setup functions are found under the System Setup menu:

1. General Setup

The General Setup sub-menu handles the basic settings of the EKP-IV:

• Beeper – Each key press, warning and alarm message sounds an audible ‘beep’. Default is ON.

• Scale Format – Sets the map scale in the Data Window field. Options are BAR (width of the

screen is the bar length times the number displayed), LEVEL (C-Map’s cell level (A-G) designation)

or WIDTH (the distance across the screen). Default is BAR.