User manual

75
should be exercised; do not rely on GPS derived altitude.
14.5.4 Depth Unit
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ +
“DEPTH” + ‘ENTER’
Depth measurements can be displayed in Feet (FT), Fathoms (FM) or Meters (MT). The default
setting is Feet.
14.5.5 Fuel Unit
Fuel units are used in the Fuel Consumption Calculator.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “FUEL”
+ ‘ENTER’
You may select Gallons (GAL), Liters (LIT), Kilograms (KG), Pounds (LB) or British Gallons (BGAL).
The default setting is Gallons.
14.5.6 Vertical Speed
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ +
“VERTICAL SPEED” + ‘ENTER’
The Vertical Speed is used in the Vertical Navigation calculation. It can be displayed as Feet per
Minute (FT/MIN) or Meters per second (M/S) or Degrees (DEG). The default setting is Feet per
Minute.
14.5.7 Temperature
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ +
“TEMPERATURE” + ‘ENTER’
The Temperature is used in the Wind Calculation. You may select Fahrenheit (F) or Celsius (C). The
default setting is Celsius.
14.5.8 North Reference
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ +
“NORTH REFERENCE” + ‘ENTER’
The North Reference for calculations can be shown as Magnetic or True (Magnetic uses an automatic
adjustment for local magnetic variation).
The North Reference used for wind computations and runway information is always Magnetic;
all other heading, bearing and Track computations are based on the user-selected reference. The
default setting is Magnetic.
14.5.9 Coordinate System
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ +
“COORDINATE SYSTEM” + ‘ENTER+ ’
Sets the display of the Latitude/Longitude coordinates system among: