Operation Manual

98 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Indicator is connected to the same ISDN bus or your router
PC is connected to a PBX that requires configuration of EAZs
to address the interfaces of an ISDN-Controller.
If this is true for your situation, configure the EAZ, to which the
interface of the ISDN-Controller should listen, as follows:
9a. No PBX, ISDN-Controller has direct access to the public
ISDN:
Replace the last digit (0) of your ISDN subscriber number
with the EAZ and enter the resulting number in the ISDN
Number field (see above). Repeat the EAZ here.
Example: EAZ: 7; ISDN subscriber number: 5502150
-> entry for ISDN Number: 5502157; entry for
EAZ: 7
9b. ISDN-Controller connected to a PBX:
How EAZs are configured in this case depends on the type
of PBX used. Therefore ask your PBX specialist, whether
you have to
- replace the last digit of the PBX Extension with the EAZ.
The EAZ must be repeated here.
Example 1: EAZ: 7; PBX Extension: 210
-> entry for PBX Extension: 217; entry for EAZ: 7
or
- add the EAZ to the PBX Extension. The EAZ must be
repeated here as well.
Example 2: EAZ: 7; PBX Extension: 210
-> entry for PBX Extension: 2107; entry for EAZ: 7
Possible values for EAZ range from 0 to 9.
10. Press <Enter> on Expert Configuration and continue with
"Expert Configuration of ISDN Interface <Name> ".