Operation Manual

Configuring Boards 89
parameters for the ISDN-Controller(s) next. To configure inter-
faces, go to the next Chapter, "Configuring ISDN Interfaces".
Procedure
Enabling/Disabling an ISDN-Controller
To enable or disable an ISDN-Controller, complete the following
steps:
1. At the server prompt, type
LOAD INETCFG <Enter>
The Internetworking Configuration menu is displayed.
2. From the Internetworking Configuration menu, select
Boards, then press <Enter>.
A new window displays the list of configured boards.
3. Highlight the ISDN-Controller you want to enable (or dis-
able), then press <Tab> .
The status of the ISDN-Controller is changed from Disabled to
Enabled (or Enabled to Disabled). The <Tab> key acts as a toggle
switch.
4. Press <Esc> to return to the Internetworking Configuration
menu.
After enabling or disabling an ISDN-Controller, select the Reinitialize
System command from the Internetworking Configuration to unload and
reload boards and their interfaces.
Procedure
Important
Deleting an ISDN-Controller
To delete an ISDN-Controller, complete the following steps:
1. At the server prompt, type
LOAD INETCFG <Enter>
The Internetworking Configuration menu is displayed.
Boards.pm6 27.05.97, 11:3789