Operation Manual

88 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
9. (Optional) Enter a Comment to this Board Configuration.
10. Check the Board Status.
Options: Enabled; Disabled
Default: Enabled
Enabled means that the board driver is loaded each time the
router is started.
When a board is disabled, the driver is not loaded and the board
cannot be used.
11. Press <Esc>, select Yes to save changes to the board con-
figuration, then press <Enter>.
If there are any conflicts with the configuration parameters of
other plug-in boards, one or more messages describe them. You
must determine whether the conflict is acceptable or whether it
interferes with the operation of the router and, if necessary,
resolve it.
The Configured Boards window is redisplayed with the board you
just configured. Note that the board status is Enabled; you can
use the <Tab> key to toggle between Enabled and Disabled.
12. To configure the remaining boards, if any, repeat Step 2
through Step 11.
After you have configured the LAN boards and ISDN-
Controller(s) in your system, you have to configure interface
DS01 / DS02 / D64S leased line types offered by the German Deutsche Telekom AG. DS01 stands
for 1 data channel, one signalling channel, DS02 for 2 data channels, 1
signalling channel. D64S stands for 1 B channel, no D channel.
MDSS1 D channel protocol to be selected if your local ISDN access provides the
DSS1 protocol and you want to allow access to your LAN from users over
Mobile ISDN.
M1TR6 D channel protocol to be selected if your local ISDN access provides the
1TR6 protocol and you want to allow access to your LAN from users over
Mobile ISDN.
GSM protocol stack to be selected if you want to provide direct access to your
router over GSM-based cellular networks (Mobile ISDN-Controller M1 or M2
used).
Boards.pm6 27.05.97, 11:3788