Operation Manual

Configuring Boards 85
Figure 5-2:
Board Configuration menu
IOAddr I/O Base Address used by the ISDN-Controller.
Slot Slot number, if an AVM ISDN-Controller B1 PCI or
B1-MCA is used.
Status Status of the ISDN-Controller, which is enabled by
default.
Comment Comment you enter about the ISDN-Controller or
its configuration.
2. Press <Ins> to display the list of available drivers.
3. Scroll through the list, select the appropriate driver for the
first ISDN-Controller installed in your system, then press
<Enter>.
Options: ISDN-BRI, ISDN-PRI, ISDNWAYS.
Select ISDN-BRI, if you are using an AVM ISDN-Controller B1,
B1 PCI, B1-MCA, PCMCIA B, M1 or M2.
Select ISDN-PRI, if you are using an AVM ISDN-Controller T1 or
T1-B.
ISDNWAYS is provided to allow remote access to the NetWare
MultiProtocol Router for ISDN from NetWAYS/ISDN and PPP
clients. Special configuration information for providing remote
access is given in Chapter 15, "Configuring Remote Node Ac-
cess". Follow the instructions in this chapter to configure boards,
then refer to Chapter 15 to configure for remote node access.
After you selected the ISDN driver, the following menu appears:
Boards.pm6 27.05.97, 11:3785