Operation Manual

Basic Design of ISDN-WANs and Configuration Overview 81
Chapters Containing Further Configuration Information
3. Configure ISDN call destinations.
Refer to Chapter 7 "Configuring ISDN Call Destinations" of this
Guide.
5. Configure global parameters for the NetWare MultiProtocol
Router for ISDN.
Refer to Chapter 8 "Configuring Global Parameters" of this
Guide.
4. Configure the protocol´s software parameters.
Refer to Chapters 9 (IPX), 10 (TCP/IP), 11 (AppleTalk) and 12
(Source Route Bridge) of this Guide.
5. Bind the configured protocol to the configured ISDN interface.
The following chapter of this Guide provides important additional
configuration information and should be read as careful as the other
configuration chapters:
- Chapter 14, "Configuration Interdependencies"
The following chapters of this Guide contain information on special
configuration scenarios and should be read when required:
- Chapter 9, "Configuring IPX"
- Chapter 10, "Configuring TCP/IP"
- Chapter 11, "Configuring AppleTalk"
- Chapter 12, "Configuring Source Route Bridge"
- Chapter 13, "Advanced Configuration"
- Chapter 15, "Configuring Remote Node Access"
configuration overview.pm6 28.05.97, 00:0381