Operation Manual

80 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Configuring for ISDN Support
The steps involved in configuring NetWare MultiProtocol Router for
ISDN 3.1 and a LAN adapter board are as follows. They are all
described in the NetWare MultiProtocol Router 3.1 guides:
1. Configure the LAN board´s hardware parameters.
Refer to the NetWare MultiProtocol Router 3.1 Configuration guide,
pp. 20-22.
2. Configure the protocol´s software parameters.
In most of the cases, it should be enough to enable the network
protocol and leave the default values.
If you need more information, refer to the respective chapters of
the NetWare MultiProtocol Router 3.1 Configuration guide for IPX
(8), TCP/IP (11), AppleTalk (12) and Source Route Bridge (14).
Ignore all instructions concerning WAN configuration. You will
find information on configuring protocols for WAN connections
in the NetWare MultiProtocol Router for ISDN Installation and ISDN
Configuration guide.
3. Bind the configured protocol to the configured LAN interface.
In most of the cases, you just have to enter your network address
(IPX network address for IPX, IP address and subnet mask for
TCP/IP) and can leave the default values.
For additional information, refer to the guide and chapters
mentioned in point 2.
Configuring for LAN Support
The steps involved in configuring NetWare MultiProtocol Router for
ISDN 3.1 and an ISDN-Controller are as follows. Since this Guide
only describes the ISDN-related tasks, information is given on when
to use which Novell documentation to perform the required steps:
1. Configure the ISDN-Controller´s parameters.
Refer to Chapter 5 "Configuring Boards" of this Guide.
2. Configure network interfaces.
Refer to Chapter 6 "Configuring ISDN Interfaces" of this Guide.
configuration overview.pm6 28.05.97, 00:0380