Operation Manual

68 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Editing STARTUP.NCF Remotely
Procedure
Important
You can also use a reboot.ncf file with the following lines:
remove dos
down
exit
Make sure, however, that the server is automatically restarted from the
DOS prompt, i.e. that the ´server´ command is included in the
autoexec.bat file.
16. Continue with "Editing STARTUP.NCF Remotely."
To edit the STARTUP.NCF file remotely from a local NetWare work-
station, complete the following steps:
1. Run RCONSOLE.
If you are running a local NetWare 4.x server, the Connection
Type menu appears. Whether you are installing on a remote
server over a LAN medium or over ISDN, in either case select
SPX.
The files REMOTE.NLM and RSPX.NLM must be loaded on the remote
server before you can open a remote session to it with RCONSOLE. If
you are unfamiliar with RCONSOLE and are using NetWare 3.12, see
NetWare 3.12 System Administration. If you are using NetWare 4.x, see
NetWare 4.0 Supervising the Network.
A window displays the list of available servers.
2. To open a session, select a remote server from the list of
available servers, then press <Enter>.
3. At the server or router console prompt, type
LOAD INSTALL <Enter>
On the remote NetWare 3.12 server, the Installation Options menu
appears. Select System Options, then press <Enter>.
On the remote NetWare 4.x server, select NCF Files Options, then
press <Enter>.
4. Select Edit STARTUP.NCF File, then press <Enter>.
Be sure you select Edit, and not Create, because a STARTUP.NCF file
already exists. If you select Create, all information in the existing file is
lost.
Suggestion
Warning
Installi.pm6 27.05.97, 12:5168