Operation Manual

Installing NetWare MultiProtocol Router for ISDN 3.1 67
install, select Yes, insert your site-specific diskette, and specify a
drive, if other than the default.
If you want to install the preconfiguration later, select No and
proceed to Step 8.
9. To install the license, load the LICENSE diskette, or enter
the location of the license file.
10. When all the NetWare MultiProtocol Router for ISDN 3.1
source files have been copied to the local system, a sequen-
tial connection is established to each of the remote servers.
If any of the selected servers do not have the correct version of
RSPAWN installed, an error message is displayed. To continue,
press <Esc>, load the correct version of rspawn on the remote
server, and retry. For more information, see "Loading RSPAWN
and SPXS from RCONSOLE" above.
11. When all the NetWare MultiProtocol Router for ISDN 3.1
source files have been copied to all the selected servers, the
following message is displayed:
"Installation was successful. Bring down and
restart each server on which you installed the
software to ensure that it uses the newest NLM
files."
12. Press <Enter> to continue.
13. From the Installation Options menu, select Exit, then re-
spond Yes to the prompt to exit the product installation.
The newly installed version of NetWare MultiProtocol Router for
ISDN 3.1 is displayed in the list of Currently Installed Products.
14. For NetWare 4.1, use <Esc> to return to the Other Installa-
tion Actions menu. Select Return to the previous menu, then
Exit.
15. Reboot the remote server. At the NetWare console prompt,
type the following commands:
DOWN <Enter>
EXIT <Enter>
Installi.pm6 27.05.97, 12:5167