Operation Manual

Installing NetWare MultiProtocol Router for ISDN 3.1 63

9. Restart NetWare from the DOS prompt by typing

SERVER <Enter>

The installation is complete. Go to Chapter 4, "Configuration Over-

view".

Remote Installation and Configuration

Note

Loading RSPAWN and SPXS from RCONSOLE

Remote installation is required when you want to install NetWare

MultiProtocol Router for ISDN 3.1 on more than one server or when

the server which you want to install the product on does not have a

local CD-ROM or floppy disk drive.

Remote installation over ISDN takes about 30 minutes!

Before performing a remote installation, the RSPAWN.NLM and the

SPXS.NLM file must be copied from the CD-ROM directory,

SUPPS\ALL, to the SYS:SYSTEM directory of the server from which

you are installing and to all remote targets. If these files were previ-

ously loaded, you must unload them and reload the newer versions.

These files can be loaded locally at the server prompt or remotely

using RCONSOLE.

If the target servers are physically accessible, RSPAWN and SPXS can

be loaded manually from the server prompt. After copying new

versions of RSPAWN and SPXS to the SYS:SYSTEM directory, load the

files manually by entering

UNLOAD RSPAWN

UNLOAD SPXS

LOAD RSPAWN

RSPAWN automatically loads SPXS.

If SPXS does not unload, manually unload any NLM

(NetWare Loadable

Module

) files that depend on SPXS or down and restart the server.

Please keep in mind that for remote installation, the RSPAWN service must

not be filtered.

To copy and load RSPAWN and SPXS remotely from a local NetWare

workstation to a remote server, complete the following steps:

Note

Important

Installi.pm6 27.05.97, 12:5163