Operation Manual

60 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
5. From the Installation Options menu, select Install Product.
An Install to Servers menu displays the local server name.
6. Select Yes to begin the installation.
7. You are now asked whether you want to install preconfig-
ured files to the local server.
If you want to install one of the preconfigurations delivered with
the NetWare MultiProtocol Router for ISDN, refer to the Quick
Installation and Setup Guide for information on the files. Choose
one, select Yes at this prompt and specify the path to install it.
If you have some experience with NetWare MultiProtocol
Router for ISDN and prepared a configuration you want to
install, select Yes, insert your site-specific diskette, and specify a
drive, if other than the default.
If you want to install the preconfiguration later, select No and
proceed to Step 8.
8. To install the license, load the LICENSE diskette, or enter
the location of the license file.
9. When the NetWare MultiProtocol Router for ISDN 3.1 source
files have been copied, the following message is displayed:
"Installation was successful. Bring down and
restart each server on which you installed the
software to ensure that it uses the newest NLM
files."
10. Press <Enter> to continue.
The list of Currently Installed Products is displayed. Verify that the
version of the NetWare MultiProtocol Router for ISDN 3.1
software that you just installed is displayed in this list.
11. From the Installation Options menu, select Exit, then re-
spond Yes to the prompt to exit the product installation.
12. For NetWare 4.1, use <Esc> to return to the Other Installa-
tion Actions menu. Select Return to the previous menu, then
Exit.
The newly installed version of NetWare MultiProtocol Router for
ISDN 3.1 is displayed in the list of Currently Installed Products.
Installi.pm6 27.05.97, 12:5160