Operation Manual

58 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
1 . Log in from a workstation (equipped with a CD-ROM drive)
that is attached to the server.
You must log in as a user with enough privileges to create
directories where you want to copy the files.
2. Create a directory on the server’s hard disk to copy the
NetWare MultiProtocol Router for ISDN files.
Create a main directory called NWMPRI31.
3. Map a drive to the directory you created.
For example, if NWMPRI31 is the product directory you created,
and it is located on the SYS: volume at the same level as the
SYSTEM directory, use the following command:
> map j:=sys:\nwmpri31
4. Copy the NetWare MultiProtocol Router for ISDN software.
4a. Insert the NetWare MultiProtocol Router for ISDN 3.1
CD-ROM into the drive, and copy the contents of the
CD-ROM to the NWMPRI31 directory.
For example, you would enter the following command at
the DOS prompt to copy the contents of the CD-ROM to the
NWMPRI31 directory:
> ncopy e:\NWMPRI31\*.* J: /s /e /v
Because the files on the installation CD-ROM are located in
subdirectories, you must use the NCOPY command with
the /s option when copying files to the hard disk.
You can perform the remainder of these steps from the
server console, or you can use RCONSOLE from the work-
station. Refer to your NetWare documentation for more
information about RCONSOLE. However, the license
diskette must be physically available at the server’s diskette
drive.
5. Complete the rest of the installation by preceding to “Install-
ing NetWare MultiProtocol Router for ISDN on a Local
Server” or "Installing NetWare MultiProtocol Router for ISDN
on a Remote Server" later in this Chapter.
Procedure
Installi.pm6 27.05.97, 12:5158