Operation Manual

Installing NetWare MultiProtocol Router for ISDN 3.1 57
1. Bring down the server by entering the following commands
at the system console prompt:
down
exit
2. Copy the NetWare MultiProtocol Router for ISDN software
onto the DOS hard disk.
You must create directories on the server’s hard disk to contain
the installation files temporarily.
2a. Insert the NetWare MultiProtocol Router for ISDN 3.1
CD-ROM into the drive.
2b. Create a main directory on the hard disk called
NWMPRI31.
2c. Copy the files from the CD-ROM to the directory.
In the following command example, the NWMPRI31 direc-
tory is already created and the CD-ROM drive is designated
as drive E:.
> xcopy e:\NWMPRI31\*.* c:\NWMPRI31 /s /e /v
Because the files on the installation CD-ROM are located in
subdirectories, you must use the XCOPY command with the
/s option when copying files to the hard disk.
3. Complete the rest of the installation by preceding to “Install-
ing NetWare MultiProtocol Router for ISDN on a Local
Server” or "Installing NetWare MultiProtocol Router for ISDN
on a Remote Server" later in this Chapter.
Copying the NetWare MultiProtocol Router for ISDN 3.1 Files to a Local
DOS Partition
Copying the NetWare MultiProtocol Router for ISDN Files to a Local Net-
Ware Volume
To install NetWare MultiProtocol Router for ISDN files from the
NetWare volume of your local server’s hard disk, complete the
following steps:
Procedure
Installi.pm6 27.05.97, 12:5157