Operation Manual

Installing NetWare MultiProtocol Router for ISDN 3.1 55
Installing NetWare MultiProtocol
Router for ISDN 3.1
3
c h a p t e r
This chapter tells you how to install the NetWare® MultiProtocol
Router
TM
for ISDN 3.1 software on a local and on remote servers.
For remote and multiple server installation, see "Remote Installation
and Configuration" later in this Chapter.
If you are doing a first-time installation, you must have
♦ Installed LAN boards
Refer to your LAN board manual for installation information.
♦ Installed one or more ISDN-Controller(s)
Refer to your ISDN-Controller manual and the information in
Chapter 2, "Prepare for ISDN Access", of this Guide.
♦ Installed the NetWare operating system
Refer to "Where to Go from Here" on p. 54 of this Guide for infor-
mation on where to find installation instructions for the NetWare
operating system.
This chapter contains the following sections:
- "Installation Setup" on page 56
- "Installing NetWare MultiProtocol Router for ISDN on a Local
Server" on page 59
- "Remote Installation and Configuration" on page 63
- "Deinstallation" on page 70
For information on upgrading from versions 2.0, 2.1, 2.11 and 3.0 to version
3.1 of the NetWare MultiProtocol Router for ISDN, refer to the special
upgrading manual coming with your upgrade product.
For information on interoperability with other products and PPP over ISDN,
refer to Chapter 2, "Preparing to Install" of this Guide.
Checklist
Important
Important
Installi.pm6 27.05.97, 12:5155