Operation Manual

52 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Before installing your ISDN-Controller(s), check the following:
♦ Normally, the transfer mode "unrestricted digital information",
which stands for data transmission (instead of, e.g. voice transmis-
sion) and allows data transmission over ISDN, is provided by
standard for every ISDN access. To reassure that this transfer
mode has been enabled for your ISDN access, please check your
order form for your ISDN access or ISDN accesses, or contact
your local PTT’s office.
♦ Check with your local PTT whether Advice On Charge During Call
(AOCD) is enabled at your ISDN access. This is required for a
number of functions provided with the NetWare MultiProtocol
Router for ISDN.
Install ISDN-Controllers
Test Your ISDN-Controllers
Checklist
Prepare for ISDN Access
Install, configure and test your AVM ISDN-Controller(s) as described
in the respective ISDN-Controller manual.
If you want to install more than one ISDN-Controller, make sure that
each ISDN-Controller has a unique I/O base address.
Write down all settings (PC bus parameters, such as I/O addresses
and slot numbers) and plug the ISDN-Controllers into the server/
router PC. You will have to provide this information when configur-
ing the ISDN-Controllers later.
If you are using AVM ISDN-Controllers PCMCIA B or Mobile ISDN-Control-
lers M1 or M2, make sure that the card and socket services are enabled.
For information on how to do this, refer to your computer manual.
Important
Use the test software provided with the AVM ISDN-Controllers to
reassure that you installed the ISDN-Controllers properly and that
your ISDN access is working:
- Use the test programs to verify that your ISDN-Controller is
correctly installed and configured and whether it can be ad-
dressed by your PC.
Preparin.pm6 27.05.97, 21:0852