Operation Manual

46 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
-
♦ The system should start DOS from the hard disk. NetWare is
started from DOS before it takes over the system hardware
completely.
It should run DR DOS® 6.0 software (or later) or Novell DOS 7.0
(or later).
Alternately, it should run MS-DOS version 3.1 (or later) if it has an
ISA or EISA bus.
Alternately, it should run MS-DOS version 3.3 (or later) if it has a
Micro Channel bus.
♦ The system must not load any modules that manage extended
memory, such as HIMEM, QEMM, or EMM386.
♦ The system must not load any modules that compress disk files,
such as Disk Doubler.
♦ The system must not load any terminate-and-stay-resident (TSR)
modules.
♦ The system should have at least 16 MB of RAM available if you
plan to run NetWare 3.12 The system should have at least 16 MB
of RAM available if you plan to run NetWare 3.12 Runtime (or
NetWare 4.1), the NetWare MultiProtocol Router for ISDN 3.1
software, and another networking product.
Supplemental Files
Checklist
Several supplemental files are included on the NetWare MultiProto-
col Router for ISDN 3.1 CD-ROM. These supplemental files provide
a variety of updates to non-NetWare MultiProtocol Router for ISDN
3.1 modules that corect problems and improve the performance of
NetWare MultiProtocol Router for ISDN 3.1. These files include
updates for tine synchronization and NDS synchronization, PBURST
updates and IPX and SPX connectivity updates. For more informa-
tion, refer to the NetWare MultiProtocol Router 3.1 Release Notes, pp.
36-41.
Preparin.pm6 27.05.97, 21:0846