Operation Manual

Monitoring ISDN Connections 251
Total Inactivity Time is the total amount of time the interface has been physically disconnected
Count since the ISDN interface was loaded. Note that at any given time either the
Total Physical Connection Time Count or the Total Inactivity Time Count
increases, depending on whether this ISDN line is physically in use or not.
Physical Up-Time shows the Maximum Physical Connection Time threshold as configured in
Threshold the ISDN-Controller Expert Interface Configuration. As soon as this threshold
is reached, the interface of the ISDN-Controller is barred.
Actual Physical shows the actual physical connection time of the interface.
Up-Time
Outgoing Calls shows the Maximum Outgoing Calls threshold as configured in the ISDN-
Threshold Controller Expert Interface Configuration.
Actual Outgoing Calls shows the actual outgoing calls over the interface.
Charging Threshold shows the Maximum Charging threshold as configured in the ISDN-Control-
ler Expert Interface Configuration.
Actual Charging shows the actual charge units accrued for connections over the interface.
Current Active is the name of the remote LAN that is connected to this interface.
ISDN Number is the ISDN Number of the remote site that is connected to this interface.
Remote Client Node is the MAC Address used by the remote node.
Address
Remote Client IP is the IP Node Address used by the remote node.
Address
Current Charge Units is the approximate number of charge units for a specific ISDN link over this
Count interface (see "Current Active Call Destination"). If no values are shown here,
refer to the note following this table.
Current Inactivity shows the Inactivity Timeout value (in seconds) configured in the ISDN Call
Timeout Value (sec) Destination Configuration assigned for this connection. When Self-Learning
Timeout is enabled, the adjusted Inactivity Timeout value is displayed in this
place.
Current Disconnect is the Disconnect Timeout value (in seconds) that has been configured in the
Timeout Value (sec) ISDN Call Destination Configuration for this connection. When Self-Learning
Timeout is enabled, the adjusted Timeout value is displayed in this place.
MONITORI.PM6 27.05.97, 23:52251