Operation Manual

230 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
The MPR for ISDN Server in the AVM Data Call Center (ADC) in
Berlin can be used as a test destination, for example if you configure
your first router and do not have an own remote site to connect to.
You may further dial-up the AVM Data Call Center from time to time
to check for any news and downloads, such as Release Notes on new
products or enhancements to existing products.
To access the NetWare MultiProtocol Router for ISDN in the AVM
Data Call Center, you will need the following connection parameters:
♦ Calling information:
ISDN Number: 03039984350 (when calling from somewhere in Ger-
many)
Subaddress: 1
For calls from outside Germany, complete the Destination Address by
first entering your international dialing prefix and the country code
"49" for Germany, and then continue with "3039984350".
♦ Protocol specifics
Currently, only IPX/SPX is enabled on this router. The internal net-
work numbers of the intranet are 39984xxx. Do not configure this
number on your router too if you want to connect to AVM’s ISDN
Service Router, since this number must be unique within a WAN. Fur-
ther, make sure that it is not filtered.
TCP/IP will be enabled in the future. Access information will then be given in
the Technical Note on NetWare MultiProtocol Router for ISDN 3.1 .
♦ Login information
Server: adc
User name: guest.avm
Password: no password required
Calling the AVM Data Call Center
Performing a TCP/IP Loopback Test
Note
After configuring the router software, you can first run a loopback
test to check your ISDN access as well as the configuration of your
router. To perform such a loopback test you will configure your local