Operation Manual

Testing and Troubleshooting 229

Testing and Troubleshooting

c h a p t e r

This chapter describes possibilities to test your ISDN access and the

configuration of your router and discusses solutions for common

problems.

This chapter contains the following sections:

- "Testing Possibilities" on page 229

- "Troubleshooting Tips" on page 235

The following sections provide a set of procedures for verifying the

correct operation of NetWare MultiProtocol Router for ISDN. Once

you have correctly and completely installed and configured NetWare

MultiProtocol Router for ISDN, testing the router is relatively easy.

You can do the following to test your router:

♦ Establish an IPX connection to the NetWare MultiProtocol Router

for ISDN in the AVM Data Call Center to check your ISDN access

and your router configuration.

♦ Perform a TCP/IP loopback test to check your ISDN access and

your router configuration.

♦ Use ISDNCHK.NLM to verify correct configuration of the Periodic

Update Interval.

For more information on ISDNCHK.NLM, refer to Chapter 16 of

this Guide, "Utilities".

♦ Use IPXPING to test reachability of an IPX target node on your

internetwork.

♦ Use TPING/PING to test reachability of an IP target node on your

internetwork.

Testing Possibilities