Operation Manual

218 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
1. Enter the Maximum Number of Remote Nodes.
This parameter defines the maximum number of remote nodes
that can be handled on the NetWare MultiProtocol Router for
ISDN.
Default: 256
Options: 0 - 2048
Specify the maximum number of remote nodes you want to
allow access to the NetWare MultiProtocol Router for ISDN.
Each active remote node requires 6 KB of RAM on the router PC.
2. Check the IPX Broadcast Filter.
This parameter specifies whether all IPX broadcasts not directed
to a specific remote client are filtered.
Default: Enabled
Options: Enabled, Disabled
When the IPX Broadcast Filter is enabled, all IPX broadcasts that
are not directed to a specific remote client, i.e. broadcasts with
the destination type FF.FF.FF.FF, are filtered.
Note
Figure 15-1:
Global Remote Node Configuration Menu
Procedure
Remoteno.pm6 27.05.97, 21:14218