Operation Manual

Configuring Remote Node Access 217
network number is set to one and each bit of the address host
number is set to zero (FF.0.0.0).
6. Select RIP Bind Options.
6a. Set the Status to Disabled.
6b. Leave the defaults for the other parameters.
Press <Esc> to return to the Binding TCP/IP to a LAN Inter-
face menu.
7. Select OSPF Bind Options.
7a. Set the Status to Disabled.
7b. Leave the defaults for the other parameters.
8. Press <Esc> until you are again at the Internetworking
Configuration main menu and save your changes when
prompted.
Configuring Global Remote Node Parameters
Global parameters for remote nodes include the Maximum Number
of Remote Nodes and general parameters for IPX and TCP/IP. They
apply for all remote nodes dialing into the NetWare MultiProtocol
Router for ISDN.
The parameter path is as follows: load INETCFG > select Network
Interfaces > select Global Remote Node Configuration.
The following menu is displayed:
Remoteno.pm6 27.05.97, 21:14217