Operation Manual

216 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
9a. Set the NLSP State to Off.
Press <Esc> to return to the Binding IPX to a LAN Interface
menu.
10. Press <Esc> until you are again at the Internetworking
Configuration main menu and save your changes when
prompted.
Binding IP to ISDNWAYS
Procedure
1. From the Internetworking Configuration menu, select Bind-
ings.
2. Press <Ins> and select TCP/IP from the list of configured
protocols.
3. Select your ISDNWAYS ´board´ from the list of configured
network interfaces.
The Binding TCP/IP to a LAN Interface menu is displayed.
4. Enter the IP address assigned to this interface, then press
<Enter>.
This is the node´s local IP address on the network connected to
this interface. The address must be entered as four decimal or
hexadecimal numbers separated by dots. Each IP address on an
IP internetwork must be unique and is usually assigned by the
network administrator.
5. Enter the subnetwork mask of the network attached to this
interface in the Subnetwork Mask of Connected Network
field, then press <Enter>.
This setting must match the mask used by the other nodes on the
network. You can enter the subnetwork mask in decimal or
hexadecimal form.
If you do not specify the mask, the standard IP network mask is
used. You can use the default subnetwork mask if your network
is not subnetted. In the standard mask, each bit of the address
Remoteno.pm6 27.05.97, 21:14216