Operation Manual

212 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
- "Binding IPX to ISDNWAYS" on page 215
- "Binding IP to ISDNWAYS" on page 216
- "Configuring Global Remote Node Parameters" on page 217
- "Access From Mobile NetWAYS/ISDN Clients" on page 222
The configuration for remote node access on the NetWare MultiProto-
col Router for ISDN consists of the following steps:
♦ Enable ISDNWAYS
To allow remote access from remote nodes, you only have to load
ISDNWAYS once, irrespective of the number of ISDN-Controllers you
want to configure.
♦ Configure an interface to be used for remote node access
♦ Configure protocols
♦ Bind IPX and/or TCP/IP to ISDNWAYS
♦ Configure Global Remote Node Parameters
Important
Procedure
Enabling ISDNWAYS
ISDNWAYS is the driver for remote node access to the NetWare
MultiProtocol Router for ISDN 3.1.
Perform the following steps to enable the ISDNWAYS driver on the
NetWare MultiProtocol Router for ISDN:
1. Load INETCFG and select Boards.
2. Press <Ins> to add a new board.
3. Select ISDNWAYS from the list of available drivers.
4. Specify a Board Name for ISDNWAYS.
5. Press <Esc> twice and answer Yes to the prompt to save
your changes.
The NetWAYS/ISDN driver is now loaded each time the router is
started or reinitialized.
Remoteno.pm6 27.05.97, 21:14212