Operation Manual

194 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
DS01, DS02 and D64S Leased Line Connections
added to the ISDN Number for international connections to mark the
end of the number to be dialed.
Ask your ISDN provider whether there is a dialing suffix for the
country you want to connect to.
For connections from Belgium to Germany, for example, the character
to enter is #.
Configuration of the NetWare MultiProtocol Router for ISDN 3.1 for
leased lines is as follows:
1. Select the appropriate D Channel Protocol when configuring
your ISDN-Controller(s) on each site.
This is either DS01, DS02 or D64S.
2. Configure only one interface of your ISDN-Controller.
2a. Enter an ISDN Number at both sites.
Configuration of an ISDN Number is required because of
protocol dependencies on the network protocol layer.
Example:
Router A: ISDN Number: 10
Router B: ISDN Number: 20
2b. Leave the defaults in the Expert Configuration of ISDN
Interface <Name>.
2c. In the Default Call Destination Configuration of ISDN
Interface <Name>, set the Encapsulation Protocol to
either AVM Proprietary or PPP.
3. Configure an ISDN Call Destination at each site.
3a. Set the Call Type to Permanent.
3b. Select an Encapsulation Protocol.
3c. Specify the ISDN Number of the respective remote site.
In our example, this would be:
Procedure
Advanced.pm6 27.05.97, 11:15194